Concrete pumping in Fresno offers the quickest and most cost-effective way for putting concrete on construction projects. But, this procedure isn’t without risk and frequently poses a lot of dangers. Of course, there are dos and don’ts of concrete pumping to prevent accidents on the site.
Responsibilities of the Contractor
The key to lowering safety problems at the worksite of concrete pumping is organization. Therefore, the contractor in charge must be accountable for seeing that the correct tools are ordered for the requirements of the project. The contractor must also be accountable for recognizing possible hazards and improving risky conditions to avoid accidents.
Preparing the Worksite
Before the pumping stage, site preparation should start first. Make sure to eliminate every mess and clear out few spaces for the pumper. The space has ideally been flattened and is big enough to manage a pump using outriggers that are extended. In addition to that, there must be enough space to manage several mix trucks.
While pumping concrete, power lines cause the most severe mishaps. All staff must obtain power line and electricity safety training to reduce or avoid these kinds of misfortunes.
Proper cribbing is important to distribute the balance or weight of the cement load. Pump suppliers usually do manufacture several outrigger pads with the pumping gear. Also, contractors might have an additional supply of wood dunnage or steel plates that could be utilized for extra cribbing when required.
Bad outrigging process could cause a lot of accidents on construction worksites when pouring concrete, aside from the powerline accidents. Usually, an unrecognized void underground can be the cause of tip overs.
When it comes to maintaining the steadiness and safety of the outriggers, the type of soil could be a vital factor. Every type of soil could have a various capacity of bearing load. For instance, substituting virgin ground with compact gravel multiplies its support capabilities by more than 2. In several conditions, tip overs happen when outriggers haven’t extended completely.
Dos of Concrete Pumping
Don’ts of Concrete Pumping
Leave a Reply